Fold 1.0.7 Beta (macOS)

Fold 1.0.7 Beta (macOS)
  • Version
  • Download 254
  • File Size 5.40 MB
  • File Count 1
  • Create Date July 15, 2021
  • Last Updated July 15, 2021

Fold 1.0.7 - 07/15/2021

Change Log: VST3, AU, and AAX

  • LFO reset automation is now available through the DAW.
  • Filter response now corrected when filters are fully open.
  • Updated presets. Now reflect changes to filter design.
  • LFOs are now hard synced to nearest tick from DAW.
  • LFO LED is now white.
  • Presets no longer snap to last selected preset when the UI is closed and then opened again.



Fold 1.0.5 - 06/30/2021

Change Log: VST3, AU, and AAX

  • Updated presets.
  • New local mix sliders UI design.
  • New LFO UI design including rate visual feedback indicated by LED.
  • New stereo spread and volume UI design.
  • Crush scaling has been scaled through user feedback.
  • New envelope follower iconography.
  • Optimized the panel on/off switches


Fold 1.0.1 - 05/08/2021

Change Log: VST3, AU, and AAX

  • Dedicated drop-down menu for oversampling.
  • LFOs for HP and FX.
  • FX is now a true dry/wet control.
  • Ganged latch control for Drive and Fold.
  • On/Off buttons for main module sections.
  • Local FX amount controls per DSP module panel (gold bars).
  • Improved parametric smoothing (reduced artifacts in audio output).
  • Mono/Stereo mode has been reconfigured to a M/S stereo width control. This only works with a stereo input audio source. The parameter is effectively moot with a mono source.
  • Envelope follower for FX panel (dry/wet). i.e., The louder the post LP processing, the more Wet the signal becomes.


Forthcoming optimizations:

  • Crush rate output will be stepped and not continuous to remove unwanted ‘clicking’ in audio output at lower crush amounts.
  • We also may limited OS factor when Crush is engaged.
  • Additional smoothing for LFO outputs.
  • UI improvements: local dry/wet to control module panel brightness; LFO rate reflected in rotary slider ring of mapped parameter; possible slider handles for local dry/wet.


Bugs we’re aware of so far that we’re working on for the next beta installer:

  • Locked parameters still visible pre-authorization. We need to grey those out or hide them entirely.
  • Assertion/crash when signal is pushed too hard beyond bounds of scope.

Leave a Reply