Fold 1.0.9 - 07/25/2021

Change Log: VST3, AU, and AAX

• LFO optimizations. Faster refresh rate. LFO bypassed when amount is zero.
• LFO waveform types are not controllable via automation.

Fold 1.0.7 - 07/15/2021

Change Log: VST3, AU, and AAX

• LFO reset automation is now available through the DAW.
• Filter response now corrected when filters are fully open.
• Updated presets. Now reflect changes to filter design.
• LFOs are now hard synced to nearest tick from DAW.
• LFO LED is now white.
• Presets no longer snap to last selected preset when the UI is closed and then opened again.

Fold 1.0.5 - 06/30/2021

Change Log: VST3, AU, and AAX

• Updated presets.
• New local mix sliders UI design.
• New LFO UI design including rate visual feedback indicated by LED.
• New stereo spread and volume UI design.
• Crush scaling has been scaled through user feedback.
• New envelope follower iconography.
• Optimized the panel on/off switches

Fold 1.0.1 - 05/08/2021

Change Log: VST3, AU, and AAX

• Dedicated drop-down menu for oversampling.
• LFOs for HP and FX.
• FX is now a true dry/wet control.
• Ganged latch control for Drive and Fold.
• On/Off buttons for main module sections.
• Local FX amount controls per DSP module panel (gold bars).
• Improved parametric smoothing (reduced artifacts in audio output).
• Mono/Stereo mode has been reconfigured to a M/S stereo width control. This only works with a stereo input audio source. The parameter is effectively moot with a mono source.
• Envelope follower for FX panel (dry/wet). i.e., The louder the post LP processing, the more Wet the signal becomes.

Forthcoming optimizations:

• Crush rate output will be stepped and not continuous to remove unwanted ‘clicking’ in audio output at lower crush amounts.
• We also may limited OS factor when Crush is engaged.
• Additional smoothing for LFO outputs.
• UI improvements: local dry/wet to control module panel brightness; LFO rate reflected in rotary slider ring of mapped parameter; possible slider handles for local dry/wet.